LIMITED NON-TRANSFERABLE WARRANTY
- Effective from the date of purchase: Used and repaired
long blocks (limited to internal parts within the long block only),
transmissions, short blocks & cylinder heads are warranted
against defects and failure for 6 months. Some special order items
are warrantied for 3 months. Shinwa can make exchange, repair, or refund
of pro-rated price according to its time usage, at
Shinwa’s discretion.
- The following consequential losses
such as cost of labor, tow charges, freight charges,
car rental charges, down time of inconveniences or litigation are NOT
COVERED UNDER THIS LIMITED WARRANTY.
- NO WARRANTY for the following accessories
such as:
- Long block-Smog Emission Devices (Distributor,
carburetor, intake/exhaust manifold), starter, alternator,
brackets, clutch assembly, dipstick tube, flywheel, EGR valve, fuel
pump, fuel injection system, oil pan, oil pick up tube, oil pressure
& water temperature sending unit, timing belts, oil pump, pulley, seals,
valve cover, water pump, turbo chargers, gaskets, etc.
- Transmission-Neutral safety switch, electrical
switches, oil pan, oil filter, overdrive sending unit switch, seals,
torque converter, shifting linkage, speed armer, throttle cable, throw-out
bearing, wiring system, solanoids, etc.
- WARRANTY will be VOIDED if the following requirements
were not met:
- All required California Emission Control Devices
must be checked for compatibility and transferred to the replacement
unit prior to installation.
- Unit must be installed by a qualified licensed
mechanic.
- Oil and oil filter must be changed prior to starting
engine. It is to be repeated after 600 miles and thereafter
according to manufacturer’s specifications.
- Oil pans, dipstick tubes, valve covers, flywheels,
etc., should be changed if different.
- Timing belts must be replaced.
- Radiator must be flow and pressure checked, repaired
or replaced.
- Thermostat, thermo sensor, water pump, radiator
hoses must be replaced.
- Temperature and oil gauges must be in proper
working condition.
- Keep all service and maintenance records including
date of installation, mileage, parts replaced, serial numbers, etc.
- HEAT TAB on used long block must not be removed
or melted.
- Front and rear crank seals must be replaced.
- All external seals, fluid and filter on transmissions
must be replaced.
- Please flush the transmission cooler lines and
change kick down cable. Make sure torque converter is put all
the way into the front pump. Prior to starting the engine, transmission
fluid must be filled. Some front wheel transmissions (such as Toyota
Camry, Tercel, Corolla,...) fluid must be also filled on the differential
side.
- WARRANTY will be VOIDED if units were damaged
as a result of overheating, lack of lubrication, lack of regular maintenance,
improper installation, accident, being taken apart without Shinwa’s
authorization, using wrong oil/fluid, misuse, abuse, commercial use,
off road use (racing), etc.
- Exchange cores must be returned within 30 days
for refund. Shinwa shall not be held liable for cores once exchanged.
|